Two pullers the other way from the back's first step.
Power
Gap runPower is a gap run with an extra blocker at the point of attack. The play-side line blocks down, the fullback kicks out the end man, and the backside guard pulls through the hole to lead on the play-side linebacker. The back follows the puller downhill.
Workable. Eight in the box with the strong safety rolled down: the extra hat. The puller takes the Sam, and the safety comes down to make the stop at 4.
Step 1: Down blocks
- Formation
- I-formation, 21 personnel
- Hole
- Inside the kick-out, off the tight end
- Puller
- Backside guard, up to the backer
Step by step
Every player's job
- CGTYPlay-side line
- Block down. Nobody through your inside gap.
- Double the down lineman, then one climbs.
- GBackside guard
- Pull flat, eyes inside.
- Turn up through the hole on the play-side backer.
- TBackside tackle
- Hinge to cut off the backside.
- FBFullback
- Kick out the end man from the inside.
- Inside shoulder, keep him wide.
- RBRunning back
- Patient first steps, then follow the puller.
- Get downhill. Don't bounce power.
- QBQuarterback
- Open, hand off deep, carry out the fake.
Practice the read
Who does the fullback block?
Frozen at step 4, vs Cover 3. Tap a player on the board or pick below.
Quiz your players on it in SnackCoaching points
- Mistake 1
The fullback tries to kick out an end who is squeezing the down blocks, and the hole closes.
Kick him out if he's wide. If he squeezes, log him: seal him inside, and the puller and the back bend it outside you.
- Mistake 2
The pulling guard turns up too soon, or runs past the hole looking for someone to block.
Pull flat with your eyes inside. Turn up through the hole inside the kick-out and take the play-side backer.
- Mistake 3
The back bounces power outside when the hole looks tight.
Patient first steps, then stay on the puller's hip and get downhill. Power hits inside the kick-out: don't bounce it.
Against each coverage
Variations
Double teams and no puller. The same downhill idea.